|
The gas fired heaters consist of two
concentric helical coils which has the advantage of:
• Compactness
• High Efficiency
• Low Thermal Mass
The dual helical coil design allows
maximized heat transfer, minimises thermal stresses and
prevents overheating. The coil design has the advantage that
ensures high fluid velocities, low film temperatures and no
accumulation of gases.
The burner can be selected to suit the
application, type of fuel – gas, oil, heavy oil, timber
and turndown. The flame shape is carefully matched to the coil
configuration. Typical efficiency with air preheating can range
up to 88 per cent depending on thermal fluid outlet
temperature, fuel, and atmospheric conditions.
Each heater has a pre wired control panel
that ensures safe and efficient operation of the heater.
|
|
As well as supplying heaters, we can provide
skid mounted units that incorporate primary and secondary pumps,
expansion tanks, stack and drain/fill tanks.
There are a myriad of applications that are
suitable for hot oil heating.
• Tank Heating –
Bitumen, Wax, Emulsions
• Reactor Heating –
Chemical Industry, BioTech
• Platen Presses – Timber
Industry, Moulding
• Hollow Flight Screws –
Mineral Processing
• Pipe Tracing – Heavy
Fuel Oil, Bitumen, Wax
• Ovens – Printing,
Automotive
• Extruders – Plastic
• Fryers – Food
• Calendar Rolls –
Plastic, Film
• Autoclaves – Aerospace,
Rubber, Brick
• Dryers – Timber, Food
• Kilns – Timber
Gasco can supply a stand-alone heater or a
total engineered package to suit any or all of the above
applications. Turnkey bitumen heating is a speciality.
|
