Top: Gasco designed, supplied, installed and commissioned Regenerative Thermal
Oxidizer (RTO) plus all Ductwork and Instrumentation from six Paint Ovens to
RTO for Toyota Australia, Altona Victoria.
Centre: Gasco RTO on Transporter Awaiting Loading on Ship at BAE Systems
Melbourne, Victoria Australia.
Bottom: Stack for RTO during loading onto ship at BAE Williamstown, Victoria,
Australia.
One of today’s most widely accepted air pollution control technologies across industry is a
regenerative thermal oxidizer, commonly referred to as a RTO. They are very
versatile and extremely efficient – heat recovery efficiency can reach 95%. This is achieved through the storage of
heat by ceramic media. In some applications, the use of catalyst with the
ceramic media helps allow oxidation at reduced temperatures resulting in even
lower operating costs. Regenerative Thermal Oxidizers are ideal in low VOC concentrations and during
long continuous operations.
Industries that may require a Regenerative Thermal Oxidizer
Adhesive Coating, Aerospace Painting, Air Strippers, Ammonia Streams,
Automotive, Bakeries, Food Processing, Chemical Processing, Coil Coating, Co
Destruction, Ethylene Oxide, Film Coating, Flexographic Printing, Flexible
Packaging, Foil Coating, Formaldehyde, Graphic Arts, Heat-Offset Printing,
Laminating, Metal Decorating, Paint Finishing Plastics, Expanded Foam,
Petrochemicals, Phenolic Resins, Pulp & Paper, Processing Refinery Off-Gas, Rendering, Spray Coating, Tank Vent, Tape
Coating, Tube Coating.
LNG Plant Acid Gas RTO
Gasco has broken new ground by supplying to Woodside an RTO for the destruction
of BTEX in CO2 Acid Gas. The RTO, Process Fans, platforms and ladders have all been
pre-assembled and shipped as a single module approximately 25m long x 15m wide
x 10m high and weighing 270 tonnes. Additionaly two x 50m tall cyclone
resistant stacks for exhaust and emergency bypass are included.
